The temperature regulator operation is
based on heating/regulation curve which we
obtain by means of choosing points including
both the expected temperature and the
reference temperature, by choosing a ready
made curve or by changing options for room
regulation. The regulator preserves the temperature
with the heating source suitable for
the reference point (e.g outer or inner temperature),
chosen during configuration phase.
Regulation algorithm causes the heating
costs lower and the same gives full comfort of
room and weather regulation. The regulator
uses two sensors for proper operation. There
is also a possibility of extending its existing
connection cable up to 50 m with a cable section
of 0,2÷2,5 mm2. The reference temperature
sensor can be replaced with a standard
resistor, which causes one sensor operation
as in the standard temperature regulation.
The regulator is a perfect solution in every
situation we want to be sure there was a
full factor ciculation e.g.: cooling systems or
heating systems, but also in situations where
suitable temperature difference is necessary
for preserving best conditions with maximum
low costs e.g.: hot water circulation. Replacing
one temperature sensor with a standard
resistor has the effect of constant regulation
around one point in accordance with the adjusted
curve, close to the chosen points.
Replacing one temperature sensor with a
potentiometer with similar functions has the
effect of changing a universal regulator into a
standard temperature regulator with difference
regulation possibility by means of curve
and hysterisis. It allows to control, e.g., the
heating source in such a way its temperature
is higher than the adjusted one including difference
corresponding e.g. the ambient temperature
loss through windows, etc.